Town & Country V6-3.8L VIN L (2006)
Power Distribution Module: Service and Repair
Front Control Module
REMOVAL
1. Disconnect and isolate the negative and positive battery cables from the battery.
2. Remove the battery.
Removing Integrated Power Module
3. Using a long flat-bladed screwdriver, gently twist the Integrated Power Module (IPM) retaining clip outboard to free the IPM from its mounting
bracket. Rotate IPM upward to access the Front Control Module (FCM) retaining screws.
4. Remove the front control module retaining screws.
Front Control Module
5. Pull the FCM straight from the PDC assembly to disconnect the electrical connector and remove the FCM from the vehicle.
INSTALLATION
NOTE: Front Control Module must be programmed to the correct radio EQ curve using the DRBIII(R). This will ensure that the audio system is
operating correctly.