Town & Country V6-3.8L VIN L (2006)
3rd Row Side Impact Sensor
3. Remove the two retaining screws to the impact sensor.
4. Disconnect the electrical connector from the impact sensor and remove from vehicle.
INSTALLATION
1. Position sensor in vehicle.
2. Connect electrical connector.
3. Install the two retaining screws to the impact sensor. Torque screws to 7 N.m (62 in. lbs.).
4. Install the quarter trim panel for the side of the vehicle that you are replacing the side impact sensor.
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE
SYSTEM TEST IS NOT PERFORMED FIRST.
5. Verify vehicle and system operation.
6. Close hood.