Town & Country V6-3.8L VIN L (2006)
5. Apply a small amount of dielectric grease (PN J8126688) to the right and left supplemental front airbag sensor harness connector (Figure 7).
NOTE:
Using your finger, force the dielectric grease into the terminal pins of each supplemental front airbag sensor wiring harness connector.
6. Connect the wiring harness connectors to the right and left supplemental front airbag sensors.
7. Lower the vehicle from the hoist.
8. For vehicles that had the Fascia removed, tighten the upper fascia bolts to 50 in. lbs. (5 N.m).
9. Connect the negative battery cable to the battery.
10. Stand next to the vehicle with the driver's door closed. Reach in through the window opening, going behind the steering wheel and turn the ignition
key to the "RUN" position. Wait 10 seconds:
>
If the airbag warning light is not illuminated, the repair has been completed. No further action is required, return the vehicle to the customer.
>
If the airbag warning light was illuminated due to a supplemental front airbag sensor fault when the vehicle was brought in for this repair,
continue with Step 11 to clear the Diagnostic Trouble Codes (DTC's).
11. Use the following procedure to clear DTC's:
a. Turn the ignition key to the "OFF" position and connect the DRBIII to the vehicle.
NOTE:
The DRBIII must be at software Version 64.0 or later.
b. Turn the ignition key to the "RUN" position.
c. Press the "YES" button after the DRBIII powers up.
d. Select "DRBIII STANDALONE" and press "ENTER".
e. Select "1998-2007 DIAGNOSTICS" and press "ENTER".
f.
Select "ALL" and press "ENTER".
g. Select "PASSIVE RESTRAINT" and press "ENTER".
h. Select "AIRBAG" and press "ENTER".
i.
Select "READ DTC's" and press "ENTER".
j.
Select "STORED" and press "ENTER".
k. Press the "PAGE BACK" button and follow the screen prompts.