Town & Country V6-3.8L VIN L (2006)
Hood Sensor/Switch (For Alarm): Service and Repair
HOOD AJAR SWITCH-EXPORT
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Using a small flat blade screwdriver, pry trigger switch from the bracket on the left fender well.
3. Disconnect the hood ajar switch from the wire connector and remove from vehicle.
INSTALLATION
1. Connect the hood ajar switch to the wire connector.
2. Press the hood ajar switch into position on the bracket located on the left inner fender well.
3. Reconnect the battery negative cable.
4. Close the hood and check for proper operation.