Town & Country V6-3.8L VIN L (2006)
Trunk / Liftgate Switch: Service and Repair
Full Open Switch
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the lift gear and link rod assembly from the vehicle
3. Cut the two wires leading to the full open switch or back the wires out of the electrical connector.
4. Remove the full open switch retaining screw and remove the full open switch from the gear motor housing assembly.
INSTALLATION
1. Perform a wiring repair on the full open switch wires following the approved procedure in the Wiring section. Or install new terminals on the wire
ends and reinstall in the main lift-gate motor electrical connector.
2. Position and install the full open switch retaining screw.
3. Install the power liftgate lift gear and link rod assembly.
4. Connect the battery negative cable.
5. Using an appropriate scan tool, check any erase any power liftgate control module diagnostic trouble codes.
6. Verify power liftgate system and full open switch operation. Cycle the power liftgate through one complete open and close cycle, this will allow
the power liftgate control module to relearn its cycle with the new components.