Town & Country V6-3.8L VIN L (2006)
Refrigerant Pressure Sensor / Switch: Service and Repair
REMOVAL
NOTE: It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.
1. Disconnect and isolate the negative battery cable.
A/C Pressure Transducer Typical
2. Disconnect the wire harness connector from the A/C pressure transducer located on the liquid line.
3. Remove the A/C pressure transducer from the fitting on the liquid line and remove and discard the O-ring seal.
INSTALLATION
NOTE: Use only the specified O-ring as it is made of special material for R-134a. Use only refrigerant oil of the type required for the A/C compressor.
1. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the liquid line fitting.
2. Install the A/C pressure transducer onto the liquid line. Tighten the A/C pressure transducer securely.
3. Connect the wire harness connector to the A/C pressure transducer.
4. Reconnect the negative battery cable.
