Town & Country V6-3.8L VIN L (2006)
2nd Row Side Impact Sensor
3. Remove the two retaining screws to the impact sensor.
4. Disconnect the electrical connector from the impact sensor and remove from vehicle.
INSTALLATION
1. Connect electrical connector.
2. Position sensor in vehicle.
3. Install the two retaining screws to the impact sensor. Torque screws to 7 N.m (62 in. lbs.).
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE
SYSTEM TEST IS NOT PERFORMED FIRST.
4. Verify vehicle and system operation.
5. Close hood.
Quarter Panel Mounted
REMOVAL
1. Open hood, disconnect and isolate the battery negative cable.
WARNING: WAIT TWO MINUTES FOR THE SYSTEM RESERVE CAPACITOR TO DISCHARGE BEFORE BEGINNING ANY
AIRBAG COMPONENT SERVICE. PERSONAL INJURY OR DEATH MAY RESULT.
2. Remove the quarter trim panel for the side of the vehicle that you are replacing the side impact sensor.