Town & Country V6-3.8L VIN L (2006)
Power Steering Pump: Service and Repair
Removal and Installation
PUMP (3.3L/3.8L ENGINE)
REMOVAL
1. Remove the (-) negative battery cable from the battery and isolate cable.
2. Remove the wiper module (unit).
3. Raise the vehicle.
4. Remove the drive belt splash shield.
5. Remove the pressure hose routing bracket bolt (Fig. 9).
6. lower the vehicle.
7. Remove cap from power steering fluid reservoir.
8. Using a siphon pump, remove as much power steering fluid as possible from the power steering fluid reservoir.
9. Disconnect the pressure hose from the pump (Fig. 10).
10. Disconnect the fluid supply hose from the pump (Fig. 10).