Town & Country V6-3.8L VIN L (2006)
13. Install the brake tubes in the routing clips located on the cradle crossmember reinforcement.
14. Install the antilock brake integrated control unit (ICU).
15. If power steering cooler equipped, install the previously disconnected power steering cooler hose on the cooler. Install the clamp.
16. Install the front tire and wheel assemblies on vehicle. Install the wheel mounting lug nuts and tighten to a torque to 135 Nm (100 ft. lbs.).
17. Lower the vehicle to a level were the interior of vehicle is accessible (keeping tires off the ground).
18. With the wheels pointed approximately STRAIGHT-AHEAD, align the intermediate shaft with the steering column coupler. Assemble the steering
column shaft coupler onto the steering gear intermediate shaft. Install the pinch bolt and tighten the pinch bolt nut to 28 Nm (250 in. lbs.).
19. Remove the steering wheel holding tool.
20. Remove the brake pedal depressor.
21. Fill the master cylinder with clean, fresh Mopar Brake Fluid or equivalent, then bleed the brake system.
22. Fill and bleed the power steering system.
23. Inspect for leaks.
24. Adjust front wheel toe.