Town & Country V6-3.8L VIN L (2006)
Fig. 25 Mounting Tire Using Rotating Wheel Machine
Fig. 26 Mounting Tire Using Rotating Tool Machine
5) Mount tire on wheel following tire changer manufacturers instructions, paying special attention to the following to avoid damaging tire pressure
sensor:
a) Rotating Wheel Tire Changers - Once the wheel is mounted to the changer, position the sensor valve stem approximately 210° from the head
of the changer in a clockwise direction before rotating the wheel (also in a clockwise direction) to mount the tire (Fig. 25). Use this procedure
on both the upper and lower tire beads.
b) Rotating Tool Tire Changers - Position the wheel on the changer so that the sensor valve stem is approximately 210° from the head of the
changer in a clockwise direction from the mounting end of the tool (Fig. 26) Make sure the sensor is clear of the lower bead breaker area to
avoid damaging the sensor when the breaker rises (Fig. 26). Rotate the tool in a counterclockwise direction to mount the tire. Use this
procedure on both the upper and lower tire beads.
6) Adjust air pressure to that listed on Tire Inflation Pressure Label (Placard) provided with vehicle (usually applied to driver's side B-pillar). Make
sure original style valve stem cap is securely installed to keep moisture out of sensor.