Town & Country V6-3.8L VIN L (2006)
Wheel Fastener: Service and Repair
Wheel Mounting Studs - Front
WHEEL MOUNTING STUDS - FRONT
REMOVAL
NOTE: Before proceeding, Refer to Service Precautions.
CAUTION: Wheel mounting studs MUST NOT be hammered out of hub flange of hub and bearing assembly. If a stud is removed by hammering it
out, damage to hub and bearing assembly will occur leading to premature bearing failure.
1) Raise vehicle.
2) Remove front wheel and tire assembly.
Fig. 39 Front Brake Mounting
3) Remove two adapter mounting bolts securing disc brake caliper adapter to steering knuckle (Fig. 39).
4) Remove disc brake caliper and adapter as assembly from steering knuckle (Fig. 39). Hang assembly out of way using wire or a bungee cord. Use
care not to overextend brake hose when doing this.
5) Remove brake rotor from hub by pulling it straight off wheel mounting studs (Fig. 39).