Town & Country V6-3.8L VIN L (2006)
C. HB Yellow Label Inspection and Wiper Motor Replacement If Necessary
1.
Disconnect the negative battery cable.
NOTE:
To enhance customer satisfaction, remember to reset the clock when you have completed the service procedure.
2.
Remove the three nuts that secure the front wiper arms to the pivot shafts (Figure 13).
3.
Using a suitable two jaw puller, separate the wiper arms and the link from the wiper pivot shaft.
4.
Remove the two cowl screws (Figure 13).
5.
Remove the five push pin fasteners and discard them (Figure 13).
6.
Lift the cowl grill off and place it away from the work area.
7.
Unlock the red lock tab on the wiper module wire connector and disconnect the wiring harness connector from the wiper motor (Figure 14).
8.
Insert the nose of a pair of 90o needle nose pliers underneath the right wiper link bushing and gently pry apart the wiper linkage from the wiper
motor crank. (Figure 15)
9.
Insert the nose of a pair of 90o needle nose pliers under the left wiper link bushing and gently pry apart the wiper linkage from the wiper motor