Town & Country V6-4.0L (2008)
7. Install the power sliding door upper track bumper.
a. Roll top edge of bumper (2) under track flange (1) ensuring the back surface of bumper is contacting the surface on track.
b. Push on left corner of bumper to positively seat retaining feature (3) into the track slot (4).
8. If removed during power sliding door drive assembly removal, install the sliding door inner seal onto the bottom of the door opening.
9. Position the hold-open striker (1) into the lower sill cavity.
10. Install the hold open striker retaining bolts. Tighten bolts, forward most bolt first, to 10 Nm (90 in. lbs).
11. Remove the lifting device supporting the door.
12. Install the sliding door drive tensioner onto the sliding door lower hinge.
a. Position the drive tensioner onto the top of the lower hinge (2) so that the alignment pin engages with the hole.
b. Install the drive tensioner retaining bolt (1). Tighten bolt to 14.5 Nm (130 in. lbs).
