Town & Country AWD V6-3.8L VIN L (2003)
18. Remove the locking pliers from the front park brake cable.
19. Adjust the park brake drum-in-hat brake shoes.
20. Install the rotor on the hub/bearing.
21. Carefully lower caliper and brake shoes over rotor and onto the adapter using the reverse procedure for removal.
CAUTION: When installing guide pin bolts extreme caution should be taken not to cross thread the caliper guide pin bolts.
22. Install the caliper guide pin bolts. Tighten the guide pin bolts to a torque of 35 Nm (26 ft. lbs.).
23. AWD only - Clean all foreign material off the threads of the outer C/V joint stub shaft. Install the washer and hub nut on the stub shaft of the outer
C/V joint.
24. AWD only - Set the parking brake.
25. AWD only - Tighten the hub nut to a torque of 244 Nm (180 ft. lbs.).
26. AWD only - Install the spring washer on the stub shaft of the outer CN joint.
27. AWD only - Install the nut retainer and cotter pin on the stub shaft of the outer C/V joint.
28. Install the wheel and tire assembly. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then
repeat the tightening sequence to the full specified torque of 135 Nm (100 ft. lbs.).
29. Lower vehicle.
30. Fully apply and release the park brake pedal one time. This will seat and correctly adjust the park brake cables.
CAUTION: Before moving vehicle, pump the brake pedal several times to insure the vehicle has a firm brake pedal to adequately stop vehicle.
31. Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake shoe linings.