Town & Country SWB FWD V6-3.3L VIN G Flex Fuel (2000)
5. Install a lug nut on the wheel stud to be removed from the hub and bearing assembly' so the threads on the stud are even with end of lug nut. Install
Remover, Special Tool C-4150A on hub and bearing assembly flange and wheel stud.
6. Tightening down on special tool will push wheel stud out of the hub and bearing assembly flange. When shoulder of wheel stud is past flange
remove special tool from hub and bearing assembly. Remove lug nut from stud and remove wheel stud from flange.
INSTALLATION
1. Install replacement wheel stud into flange of hub and bearing assembly. Install washers on wheel stud, then install a wheel lug nut on stud with flat
side of lug nut against washers.
2. Tighten the wheel lug nut, pulling the wheel stud into the flange of the hub and bearing assembly. When the head of the stud is fully seated against
the bearing flange, remove lug nut and washers from wheel stud.
3. Install the brake rotor back on the hub and bearing assembly.
4. Install front brake caliper back over brake rotor and align with caliper mounting holes on steering knuckle. Refer to the Brake and Traction
Control for the disc brake caliper installation procedure.
5. Install wheel and tire assembly on vehicle. Tighten the wheel mounting lug nuts in proper sequence until all nuts are torqued to half specification,
then repeat the tightening sequence to the full specified torque of 135 Nm (100 ft. lbs.).
6. Lower vehicle to the ground.
