Town & Country SWB FWD V6-3.3L VIN G Flex Fuel (2000)
12. Tighten the cylinder head to intake manifold strut bolts to 54 Nm (40 ft. lbs.) torque.
13. Connect ground strap and MAP sensor electrical connector.
14. Connect vacuum harness to intake plenum. Connect PCV system hoses.
15. Using a new gasket, connect the EGR tube to the intake manifold plenum. Tighten screws to 22 Nm (200 in. lbs.) torque.
16. Connect electrical connectors to the TPS and idle air control motor.
17. Connect vacuum harness to throttle body.
18. Install the direct ignition system (DIS) coils. Tighten fasteners to 12 Nm (105 in. lbs.) torque.
19. Install fuel hose quick connector fitting to chassis tubes. Push the fitting onto the chassis tube until it clicks into place. Pull on the fitting to ensure
complete insertion.
20. Install throttle cable and speed control cable (if equipped).
21. Install air inlet resonator.
22. Connect negative cable to battery.
23. Use the DRB scan tool to pressurize the fuel system. Check for leaks.