Town & Country Van V6-201 3.3L VIN R SMFI (1990)
(6)
Install fuel tube retaining bracket screw and torque to 4 N-m (35 in.lbs.) (Fig. 9).
(7)
Reconnect cam sensor, coolant temperature sensor and engine temperature sensors.
Figure 11 - Fuel Injector Wiring Clip
(8)
Install fuel injector harness wiring clips on the alternator bracket and intake manifold water tube (Fig. 11).
(9)
Connect fuel pressure regulator vacuum line.
(10) Remove covering on lower intake manifold and clean surface.
(11) Place intake manifold gasket on lower manifold. Put upper manifold into place and install bolts finger tight.
(12) Install the alternator bracket to intake plenum bolt and the cylinder head to intake manifold strut bolts. (Do not torque.)
Figure 8 - Intake Manifold Bolts
(13) Torque intake plenum bolts to 28 N-m (250 in.lbs.) following torque sequence in (Fig. 8).