Town & Country Van V6-229 3.8L VIN L MFI (1995)
Sliding Door Latch: Service and Repair
REMOVAL
1. Remove sliding door trim panel.
2. Remove water shield.
3. Remove sliding door stop bumper.
Sliding Door Latch/Lock Control Linkage
4. With sliding door ajar, disengage clip holding latch release link to latch/lock control.
5. Separate link from control.
6. Disengage clip holding outside door handle link to latch/lock control.
7. Disengage clip holding inside door handle cable end to latch/lock control.
8. Disengage tabs holding inside door handle cable case to latch/lock control.
9. Disengage clip holding lock cylinder link to latch/lock control.
10. Separate lock cylinder link from control.
11. Disengage lock tabs holding hold open latch cable case to latch/lock control.
12. Separate hold open latch cable ball end from latch/lock control.
Sliding Door Latch/Lock Control
13. Loosen bolts holding latch/lock control to sliding door.
14. If equipped, disengage wire connector from power door lock motor.
15. Separate latch/lock from vehicle.
INSTALLATION
1. Place latch/lock in position on vehicle.
2. If equipped, engage wire connector into power door lock motor.