Town & Country Van V6-229 3.8L VIN L MFI (1995)
Lifter / Lash Adjuster: Service and Repair
Disassembly and Assembly
DISASSEMBLY
1. Pry out plunger retainer spring clip.
2. Clean varnish deposits from inside of tappet body above plunger cap.
3. Invert tappet body and remove plunger cap, plunger, flat or ball check valve, check valve spring, check valve retainer and plunger spring. Check
valve could be flat or ball.
ASSEMBLY
1. Clean all tappet parts in a solvent that will remove all varnish and carbon.
2. Replace tappets that are unfit for further service with new assemblies.
3. If plunger shows signs of scoring or wear, valve is pitted, or valve seat on end of plunger indicates any condition that would prevent valve from
seating, install a new tappet assembly.
4. Assemble tappets.