Town & Country Van V6-229 3.8L VIN L MFI (1995)
Glove Box
7. Remove attaching screws and right lower panel. Screw location:
-
One screw outboard right of lower panel
-
Two screws in ash receiver/cup holder opening
-
Two screws bottom on the lower right
-
One screw in heater duct above heater control.
-
Remove glove box attaching screws and disconnect check straps.
-
Disconnect glove box lamp.
INSTRUMENT PANEL REMOVAL
WARNING: Chock wheels when instrument panel is to be rolled down. The steering column is removed and transmission may be out of
park. Release the park brake before the release cable is disconnected. Disconnecting park brake cable while park brake is engaged may
cause personal injury.
Silencer Panel
1. Remove lower left instrument panel silencer.
2. Set parking brake and shift gear selector into low.
3. Remove lower left reinforcement.
4. Disconnect transmission range indicator at column.
5. Unhook transmission range indicator cable eyelet from column actuating arm:
-
Release column insert lock tab.
-
Squeeze legs together and lift insert from steering column, leave insert free.
-
Place cable on instrument panel to avoid transmission range indicator cable damage during removal.
6. Remove steering column. See: Steering and Suspension/Steering/Steering Column/Service and Repair
7. Remove lower right instrument panel silencer.
8. Remove floor braces.
9. Remove A-pillar intermediate and sill scuff garnish moldings. Refer to: "Body and Frame : Interior Trim : Trim Panel : Service and Repair"
See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair
10. Unfasten the hood release mechanism from the side cowl.
11. Disconnect the brake light switch, parking brake switch and bulk head wiring connectors.
12. Under the hood disconnect the ABS connector and resistor block. Unseat the grommet at the dash panel and feed wiring back into passenger
compartment.
13. Remove the two nuts, securing the instrument panel, at the steering column support brace.