Town & Country Van V6-229 3.8L VIN L MFI (1995)
screw is maintained or brake pedal bottoms. If an air-free flow of brake fluid is not maintained from bleed screw before brake pedal bottoms,
close bleed screw and then repeat steps 8 and 9 until an air free flow is maintained.
11. After an air-free flow of brake fluid is maintained from the bleed screw, close and lightly tighten the bleed screw. Then release force from
brake pedal.
Do not release force from brake pedal prior to closing and tightening bleeder screw.
Note: For the next modulator assembly bleeding procedure, use of the DRB Scan Tool is not required. This step of the bleeding procedure
does not require the modulator solenoids to be operated for bleeding to be performed.
12. Pump brake pedal several times, then apply and hold constant medium to heavy force on brake pedal.
18. Again without firing modulator assembly solenoids, open secondary accumulator circuit bleed screw (Fig. 6) at least 1 full turn. This will
ensure an adequate flow of brake fluid is expelled from the secondary accumulator circuit.
14. Bleed secondary accumulator circuit until a clear, air-free flow of brake fluid is maintained from the secondary accumulator bleed screw or the
brake pedal bottoms. If an air-free flow of brake fluid is not maintained from secondary accumulator bleed screw before brake pedal bottoms.
Repeat steps 12 and 13 of this bleeding procedure until an air-free flow is maintained from the bleeder screw.
15. Alter an air free flow of brake fluid is maintained from secondary accumulator circuit bleed screw, close and lightly tighten bleed screw. Then
release force from brake pedal. Do not release force from brake pedal prior to closing and tightening bleed screw.
16. Alter secondary accumulator bleed screw is closed, remove bleed hose from bleed screw.
17. Torque secondary accumulator bleed screw to 9 Nm 80 in. lbs.).