Town & Country Van V6-229 3.8L VIN L MFI (1995)
9. On models with plastic retaining collar, while holding housing on an angle, insert each roller one at a time into retainer collar until all are seated
and locked into housing.
10. On models with wire retaining ring, slip tripod into housing and install tripod wire retaining ring.
11. On models less plastic collar or wire ring, insert tripod into housing.
12. On all models, position boot over boot retaining groove in housing. Ensure boot is not dimpled or twisted, if necessary, use a suitable blunt tool to
pry up edge of boot to allow air pressure to equalize.
13. Place new clamp into position on large end of boot, then using a suitable crimping tool, tighten clamp into place.
14. Refer to chart below for correct driveshaft length. To achieve an accurate measurement, slide small end of boot and outer housing onto
interconnecting shaft.
Driveshaft
side
dimension "A"
Type
mm
inch
GKN
right
476-486
18.7-19.1
GKN
left
184-194
7.2-7.6
15. Install clamp, then using a suitable crimping tool, tighten clamp into place.