Town & Country Van V6-229 3.8L VIN L MFI (1995)
Terminal Removal
Terminal Removal Using Special Tool
4. Position the connector locking finger away from the terminal using the proper pick from Special Tool Kit 6680. Pull on the wire to remove the
terminal from the connector.
5. Reset the terminal locking tang, if it has one.
6. Insert the removed wire in the same cavity on the repair connector.
7. Repeat steps 4 through 6 for each wire in the connector, being sure that all wires are inserted into the proper cavities.
8. Insert the connector locking wedge into the repaired connector, if required.
9. Connect the connector to its mating half/component.
10. Connect the battery and test all affected systems.
Diode Replacement
Diode Identification
1. Disconnect the battery.
2. Locate the diode in the harness and remove the protective covering.
3. Remove the diode from the harness, pay attention to the current flow direction.