Town & Country Van 2WD V6-230 3.8L VIN L SMFI (1997)
7. Install the chassis brake lines in the correct ports of the proportioning valve.
8. Install the pressure test fittings and pressure gauges in the opposite inlet and outlet port of the height sensing proportioning valve. Repeat steps 4
and 6 for the other proportioning valve.
9. Remove the pressure test fittings and pressure gauges from the proportioning valve.
10. Install the chassis brake lines in the correct ports of the proportioning valve.
11. Install the actuator on the height sensing proportioning valve. Adjust the proportioning valve actuator.
12. Bleed both rear hydraulic circuits at the rear brakes. See: Brake Bleeding/Service and Repair
13. Road test vehicle.