Town & Country Van 2WD V6-230 3.8L VIN L SMFI (1997)
Intake Manifold: Service and Repair
Intake Manifold Replacement
Removal
1.
Remove windshield wiper module (Windshield Wiper Motor Assembly). See: Wiper and Washer Systems/Wiper Motor/Service and Repair
2.
Perform fuel pressure release procedure (before attempting any repairs). See: Cylinder Head Assembly/Fuel Pressure Release
3.
Drain cooling system.
4.
Remove air inlet resonator to throttle body hose assembly.
5.
Remove throttle cable. Remove wiring harness from throttle cable bracket.
6.
Remove Automatic Idle Speed (AIS) motor and Throttle Position Sensor (TPS) wiring connectors from throttle body.
7.
Remove EGR transducer connector.
8.
Remove vacuum hose harness from throttle body.
9.
Remove PCV and brake booster hoses from air intake plenum.
10.
Disconnect MAP Sensor electrical connection.
11.
Remove EGR tube flange from intake plenum.
12.
Remove vacuum harness connectors from intake plenum.