Town & Country Van 2WD V6-230 38L VIN L SMFI (1997) Power and Ground Distribution Diagrams
Multiple Junction Connector: Service and Repair
Junction Block
REMOVAL
1. Disconnect battery negative cable.
2. Remove lower steering column cover and knee blocker reinforcement.
Junction Block
3. Disconnect four, forty-way connectors from Junction Block.
4. Disconnect two wire connectors from bottom of Body Control Module.
5. Remove bolts holding Junction Block to dash panel mounting.
6. Remove Junction Block from mounting bracket.
7. Remove screws holding Body Control Module to Junction Block.
8. Slide Body Control Module downward to disconnect guide studs on Junction Block from BCM mounting bracket.
9. Separate Junction Block from Body Control Module.
INSTALLATION
1. Join Junction Block from Body Control Module.
2. Slide Body Control Module upward to connect guide studs on Junction Block from BCM mounting bracket.
3. Install screws holding Body Control Module to Junction Block.
4. Install Junction Block from mounting bracket.
5. Install bolts holding Junction Block to dash panel mounting.
6. Connect two wire connectors from bottom of Body Control Module.
Junction Block
7. Connect four, forty-way connectors from Junction Block.
8. Install lower steering column cover and knee blocker reinforcement.
9. Connect battery negative cable.