Town & Country Van AWD V6-201 3.3L VIN R FI (1991)
Impact Sensor: Service and Repair
Before attempting to diagnose, remove or install any airbag system components, first disconnect and isolate battery ground cable, then wait
at least 10 minutes prior to performing any service. Failure to do so may result in airbag deployment or personal injury.
1.
Disconnect and isolate battery ground cable, then wait at least 10 minutes prior to performing service.
2.
Remove upper radiator closure crossmember to sensor attaching nuts.
3.
Disconnect sensor electrical connector, then remove.
4.
Reverse procedure to install. Torque sensor attaching nuts to 40-60 inch lbs.
5.
Do not connect battery ground terminal. Refer to Air Bag Systems/Testing and Inspection/Procedures for operational check procedure.