Front Wheel Bearing Service and Repair for Town & Country Van AWD
10. Remove hub and bearing assembly. Replacement of the grease seal is recommended whenever this service is performed.
Installation
1. Install new hub and bearing assembly and tighten screws in a criss-cross pattern to 45 ft.lbs. (65 Nm.).
CAUTION: Knuckle and bearing mounting surfaces must be smooth and completely free of foreign material or nicks.
2. Position new seal in recess and assemble installer Tool C-4698 tool is provided with a handle and dual purpose drive head for installing seal into
knuckle and (head reversed) for installing wear sleeve into C/V joint housing).
3. Assemble tool and install seal.
CAUTION: During any service procedures where knuckle and driveshaft are separated, thoroughly clean seal and wear sleeve and relubricate BOTH
components.