Town & Country Van AWD V6-229 3.8L VIN L MFI (1994)
Crankshaft Position Sensor: Service and Repair
Fig. 5 Crankshaft Position Sensor
REMOVAL
1. Raise and support vehicle.
2. Disconnect crankshaft position sensor electrical connector from the wiring harness connector (Fig. 5).
3. Remove crankshaft position sensor retaining bolt.
4. Pull crankshaft position sensor straight up out of the transaxle housing.
INSTALLATION
NOTES:
If the sensor is to be reused, a new paper spacer must be used. Be sure to remove the old spacer from the sensor face completely, before
attaching new spacer.
If the sensor is being replaced, confirm that there is a paper spacer attached to the face of the new sensor (Fig. 5).
1. Install sensor in transaxle and push sensor down until contact is made with the drive plate.
-
While holding the sensor in this position, and install and tighten the retaining bolt to 11.9 Nm (105 in lb) torque.
2. Raise and support vehicle.
3. Connect crankshaft position sensor electrical connector to the wiring harness connector.