Town & Country Van AWD V6-229 3.8L VIN L MFI (1994)
14.
Using a large flat-tipped screwdriver, pry the module up to unsnap the door from the trim pad and lift it away from the snaps (Figure 14).
15.
Hold the passenger airbag module door and raise the module from the opening. DO NOT disconnect the airbag module electrical connectors.
16.
Inspect the I/P wiring harness just behind the passenger airbag connectors (Figure 15). Any chafed or cut wires should be repaired per the Wiring
Repair.
17.
Install a mastic patch on the edge of the passenger airbag module near the electrical connectors (Figure 15).
