Town & Country Van AWD V6-230 3.8L VIN L SMFI (1998)
Headlamp Bulb: Service and Repair
HEADLAMP HIGH BEAM
REMOVAL
1. Release hood latch and open hood.
2. From behind radiator closure panel, disconnect wire connector from back of high headlamp bulb base.
Headlamp High Beam Bulb
3. Rotate headlamp bulb counterclockwise and pull bulb from back of headlamp module.
INSTALLATION
CAUTION: Do not touch the glass of halogen bulbs with fingers or other possibly oily surface, reduced bulb life will result.
1. Insert bulb into the back of the headlamp module.
2. Rotate headlamp bulb clockwise to engage bulb.
3. Connect wire connector to the low beam headlamp. Verify headlamp bulb operation
4. Verify headlamp alignment.
HEADLAMP LOW BEAM
REMOVAL
1. Release hood latch and open hood.
2. Remove the three headlamp mounting nuts.
3. Remove one attaching screw on top of the crossmember.
Headlamp Low Beam Bulb
4. Disconnect wire connector from the back of the low beam headlamp bulb base.