Voyager L4-2.4L VIN B (2001)
Driver/Vehicle Information Display: Service and Repair
Message Center Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Using a trim stick (special tool #C-4755) or equivalent, gently pry up on the front side of the message center and lift out of instrument panel
opening.
3. Disconnect the wire connector from the back of message center.
4. Remove message center from vehicle.
NOTE: If the message center lamp needs replacing, twist out defective bulb socket and replace with a known good bulb and socket.
INSTALLATION
1. Connect the wiring connector to message center.
2. Place message center in position on instrument panel and firmly snap into place.
3. Connect battery negative cable.
