Voyager L4-2.4L VIN B (2001)
21. Remove the four nuts attaching power brake booster to dash panel.
22. Slide power brake booster forward and remove through engine compartment.
CAUTION: Do not attempt to disassemble the power brake vacuum booster it is serviced ONLY as a complete assembly.
INSTALLATION - POWER BRAKE BOOSTER
1. Position power brake booster on dash panel using the reverse procedure of its removal. It may be necessary to push in on booster input rod as it is
guided through the dash panel.
2. Install the four nuts mounting the booster to the dash panel. Tighten the mounting nuts to a torque of 29 Nm (250 inch lbs.).
3. Using lubriplate, or equivalent, coat the surface of the brake pedal pin where it contacts the booster input rod.
CAUTION: When installing the brake pedal pin on the power brake booster input rod, do not re-use the old retaining clip.
