Voyager L4-2.4L VIN B (2001)
Fig.9 Rear Heater And A/C Lines
5. Remove (3) straps securing underbody lines.
6. Separate and remove rear heater lines from vehicle.
INSTALLATION
Fig.21 Heater Plumbing
There are several heater core plumbing configurations used on this model, depending upon the engine size and other optional equipment. One
plumbing configuration is used for all these engines. All models use a combination of formed steel tubing and rubber hoses. In most cases, the rubber
hose is secured to the steel tubing with a spring tension clamp.
WARNING: REFER TO THE APPLICABLE WARNINGS AND CAUTIONS FOR THIS SYSTEM BEFORE PERFORMING THE
FOLLOWING OPERATION.
1. Using spring tension clamp pliers, compress and slide the clamps that secure each end of the heater hose toward the center of the hose being
installed. Release the clamp when it is near the center of the hose.
2. Grasp one end of the heater hose being installed firmly and carefully twist the hose back and forth while pushing it over from the barbed end of the
nipple. Repeat this procedure at the opposite end of the hose being installed.
3. Using spring tension clamp pliers, compress and slide the clamps that secure each end of the heater hose over the tube or nipple. Release the clamp
when it is over the tube or nipple.
