Voyager L4-2.4L VIN B (2001)
3. Apply Mopar Engine RTV GEN II at the camshaft cap corners and at the top edges of the 1/2 round seal (Fig. 32).
4. Install cylinder head cover assembly to cylinder head. Install all bolts, ensuring the two 2 bolts containing the sealing washer are located in the
center locations of cover. Tighten bolts in sequence shown in (Fig. 33). Using a 3 step torque method as follows:
a. Tighten all bolts to 4.5 Nm (40 in. lbs.).
b. Tighten all bolts to 9.0 Nm (80 in. lbs.).
c. Tighten all bolts to 12 Nm (105 in. lbs.).
5. Install ignition coil and spark plug wires. Tighten fasteners to 12 Nm (105 in. lbs.).
6. If the PCV valve was removed, apply Mopar Thread Sealant with Teflon to threads and install valve to cylinder head cover. Tighten PCV valve to
8 Nm (70 in. lbs.).
7. Connect PCV and make-up air hoses to cylinder head cover.
8. Install upper intake manifold.
