Voyager L4-2.4L VIN B (2001)
13. Remove upper intake manifold bolts (Fig. 108). Remove upper intake manifold.
CAUTION: Cover intake manifold to prevent foreign material from entering engine.
INSPECTION
1. Check manifold surfaces for flatness with straight edge. Surface must flat within 0.15 per 300 mm (0.006 in. per foot) of manifold length.
2. Inspect manifold for cracks or distortion. Replace manifold if necessary.
INSTALLATION
1. Clean manifold sealing surfaces.
2. Apply a 1.5 mm (0.060 inch) bead Mopar Gasket Maker to the perimeter of the lower intake manifold runner openings.
3. Install upper intake manifold and tighten fasteners to 28 Nm (250 in. lbs.) in sequence shown in (Fig. 108). Repeat this procedures until all
fasteners are at specified torque.
4. Install engine oil dipstick.
5. Install upper bolt in intake manifold to front support bracket (Fig. 107). Torque to 28 Nm (250 in. lbs.).
6. Install EGR tube.
7. Install throttle cables in bracket.
8. Connect throttle, speed control, (if equipped), transaxle control (31TH equipped only) cables to throttle lever.
9. Connect vacuum lines for power brake booster, LDP, EGR transducer, and speed control vacuum reservoir (if equipped) at upper intake manifold
fittings.
10. Connect vacuum lines for purge solenoid and PCV valve.
11. Connect electrical connectors for MAP sensor, Throttle Position Sensor (TPS), and Idle Air Control (IAC) motor.
12. Install air cleaner upper housing and air intake tube to throttle body.
13. Connect inlet air temperature sensor connector (Fig. 104).
14. Connect negative cable to battery.