Voyager L4-2.4L VIN B (2001)
Clockspring Assembly / Spiral Cable: Service and Repair
REMOVAL
1. Position steering wheel and front wheels straight ahead.
2. Release hood latch and open hood. Disconnect and isolate the battery negative cable.
3. Remove driver airbag from steering wheel.
4. Disconnect wire connectors from back of driver airbag.
5. Disconnect the 2-way connector from remote radio control harness.
6. Remove steering wheel.
7. Remove steering column shrouds.
8. Disconnect 2-way and 5-way connectors between the clockspring and the instrument panel wiring harness.
9. Remove clockspring from housing assembly by removing the two retaining screws retaining the clock spring.
INSTALLATION
1. Position the clockspring into the housing. Install the two retaining screws to clockspring.
2. Connect the two way and five way harness between the clockspring and the instrument panel.
3. Install the steering wheel. Refer to Steering, Column, Steering Wheel, Installation.
4. Connect the harness connector to the driver airbag.
5. Connect the remote radio control harness.
6. Install the driver airbag into the steering wheel.
7. Install the steering column upper and lower shrouds.
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. REFER TO ELECTRICAL, RESTRAINTS, DIAGNOSIS AND
TESTING - AIRBAG SYSTEM FIRST.
