Voyager L4-2.4L VIN B (2001)
Clean the servo piston components (Fig. 201) with solvent and dry them with compressed air. Wipe the band clean with lint free shop towels.
Replace the front band if distorted, lining is burned, flaking off, or worn to the point where the grooves in the lining material are no longer visible.
Replace any servo component if doubt exists about condition. Do not reuse suspect parts.
INSPECTION
Inspect the servo components (Fig. 202). Replace the springs if collapsed, distorted or broken. Replace the guide, rod and piston if cracked, bent, or
worn. Discard the servo snap-ring if distorted or warped.
Check the servo piston bore for wear. If the bore is severely scored, or damaged, it will be necessary to replace the case.
Assembly
ASSEMBLY
1. Lubricate new O-ring and seal rings with petroleum jelly and install them on piston, guide and rod.
