Voyager V6-3.0L VIN 3 (2000)
11. If a low viscosity urethane adhesive is used, install compression spacers on the fence around the rear window opening Lower.
12. Apply a 10 mm (0.4 in.) bead of urethane along center line of rear window fence.
13. With the aid of a helper, position the rear window over the rear window opening and align the reference marks.
14. Slowly lower the glass to rear window opening fence. Guide the molding into proper position as necessary. Push glass inward until molding is
flush to liftgate surface.
15. Clean excess urethane from exterior with Mopar« Super Kleen, or equivalent.
16. Apply 150 mm (6 in.) lengths of 50 mm (2 in.) masking tape spaced 250 mm (10 in.) apart to hold molding in place until urethane cures.
17. Install rear window side moldings and wiper arm.
18. Install interior trim.
19. After urethane has cured, remove tape strips and water test rear window to verify repair.