Voyager V6-3.3L VIN 3 Flex Fuel (2003)
Constant Velocity Joint Boot: Service and Repair
CV Joint Bearing Shield
FRONT AXLE
Outer CV Joint Bearing Shield
REMOVAL
1. Clamp half shaft in a vise by the interconnecting shaft.
2. Using a drift (Fig. 35) tap around the entire edge of the bearing shield until it is removed from the outer CV joint.
INSTALLATION
1. Install bearing shield by hand on outer CV Joint so that it is installed squarely on the CV joint.
2. Position installer, Special Tool C-4698-2, and handle, Special Tool C-4698-1, on face of bearing shield (Fig. 36).
CAUTION: If bearing shield is not installed flush against the face of the outer CV joint, interference with steering knuckle will occur when driveshaft is
installed.