Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
CAUTION:
Ensure that Transmitters from other vehicles in the immediate area are not activated during this procedure.
13.
Continue programming Transmitters when directed by the Scan 100 Scan Tool until all Transmitters have been programmed.
Note:
A maximum of five (5) Transmitters may be programmed to a vehicle.
14.
Once all Transmitters have been programmed, press the "ESC" Button on the Key Pad. The display will confirm the number of Transmitters
programmed. If the number displayed does not match the number of Transmitters programmed, repeat the procedure.
15.
Turn the Scan 100 Scan Tool "OFF" by pressing the "POWER" Button, then disconnect it from the Data Link Connector.
16.
Wait approximately 10 seconds, then test the operation of each programmed Transmitter to ensure it operates properly.
If additional information is needed regarding this procedure, please contact your District Parts & Service Manager or the Daewoo Technical Assistance
Center toll free at (877) 362-1234, selection 1.
