Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
8. Remove the seal from the booster housing. Discard the seal.
9. Drain the brake fluid.
Installation Procedure
1. Install the master cylinder assembly with the new attaching nuts.
2. Install the new seal to the booster housing.
Tighten
Tighten the master cylinder attaching nuts to 18 Nm (13 ft. lbs.).
3. For vehicles equipped with ABS (as shown), connect the brake lines to the cylinder body.
4. For vehicles without ABS, connect the brake lines to the proportioning valves.
Tighten
Tighten the brake lines to 16 Nm (12 ft. lbs.).
5. For vehicles with the manual transaxle, connect the clip to the clutch hose connection at the master cylinder.