Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
Brake Master Cylinder: Service and Repair
Disassembly and Reassembly
Disassembly Procedure
1. Remove the master cylinder.
2. Remove the brake fluid reservoir.
3. Remove the seal ring from the cylinder bore.
NOTICE: When removing the retaining ring, avoid damaging the piston or the cylinder wall.
IMPORTANT: A welding rod or its equivalent can be used in a compensating port to keep the piston pressed down.
4. Remove and discard the retaining ring from the cylinder body using a suitable screwdriver. (The non-ABS master cylinder body is shown.)
5. Remove the primary piston. (The ABS master cylinder body is shown.)
6. Carefully remove the secondary piston assembly and the spring from the master cylinder bore.
