Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
ABS Solenoid
Removal Procedure
1. Disconnect the negative battery cable.
2. Unplug the Antilock Brake System (ABS) solenoid electrical connector.
3. Remove the Torx head bolts and the solenoid from the hydraulic modulator.
IMPORTANT:
-
Be sure that the O-ring seal is still attached to the solenoid shaft when it is removed. If not, check the solenoid bore in the hydraulic modulator.
-
Do not attempt to disassemble the solenoid; it is serviceable only as an assembly.
Installation Procedure
IMPORTANT: Verify that the solenoid O-ring seal is properly positioned before installing the solenoid into the hydraulic modulator.
1. Lubricate the seal on the solenoid with clean brake fluid.
2. Install the solenoid to the hydraulic modulator.
