Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
7. Remove the fan motor retaining screws.
8. Remove the fan motor from the shroud.
Installation Procedure
Caution: If a fan blade is bent or damaged in any way, no attempt should be made to repair or reuse the damaged part. A bent or damaged fan
assembly must be replaced with a new fan assembly. It is essential that fan assemblies remain in proper balance. A fan assembly that is not in proper
balance can fail and fly apart during use, creating extreme danger. Proper balance cannot be assured on a fan assembly that has been bent or damaged.
1. Install the fan motor to the shroud.
2. Secure the motor to the shroud with the retaining screws.
Tighten the electric cooling fan (main) motor retaining screws to 4 Nm (35 inch lbs.).
3. Install the fan to the motor with the single nut in the center of the fan hub.
Tighten the electric cooling fan (main) motor nut to 3.2 Nm (28 inch lbs.).
4. Install the electric cooling fan shroud assembly to the radiator.
Important: Be careful to seat the mounting post on the fan shroud into the socket at the radiator left tank. Be sure to slip the tab at the bottom
edge of the shroud into the retaining clip near the center of the radiator.
5. Secure the shroud to the top of the radiator with the mounting bolts.
Tighten the electric cooling fan assembly (main) mounting bolts to 4 Nm (35 inch lbs.).
6. Install the electrical connector to the cooling fan.
