Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
4. While holding the exhaust camshaft firmly in place, install the exhaust camshaft gear bolt.
Tighten the exhaust camshaft gear bolt to 67.5 Nm (49 ft. lbs.).
5. Apply a small amount of gasket sealant to the corners of the front camshaft caps and to the top of the rear valve cover-to-cylinder head seal.
6. Install the valve cover and the valve cover gasket.
7. Install the valve cover washers.
8. Install the valve cover nuts.
Tighten the valve cover nuts to 10 Nm (89 inch lbs.).
9. Connect the crankcase ventilation tubes to the valve cover.
10. Connect the ignition wires to the spark plugs.
11. Install the spark plug cover.
12. Install the spark plug cover bolts.
Tighten the spark plug cover bolts to 3 Nm (27 inch lbs.).