Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
8. Remove and discard the O-ring from the compressor neck using the O-ring remover J-9553-1.
9. Thoroughly clean the seal O-ring groove in the compressor housing.
10. Inspect the shaft and the inside of the compressor housing neck for dirt or foreign material. These parts must be perfectly clean before installing
any new parts.
Assembly Procedure
IMPORTANT: Seals must not be reused. Always use a new specification service seal kit. Be sure that the seal to be installed is not scratched or
damaged in any way. The seal must be free of lint and dirt that may damage the seal surface or prevent proper sealing.
1. Dip the new seal O-ring in clean polyalkaline glycol (PAG) refrigerant oil and assemble the O-ring onto the O-ring installer J-33011.
2. Insert the O-ring installer J-3301 1 into the compressor neck until the installer "bottoms." Lower the moveable slide of the O-ring installer J-33011
to release the O-ring into the seal O-ring lower groove. (The top groove of the compressor neck is for the shaft seal retainer ring.) Rotate the
installer to seat the O-ring and then remove the installer.