Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
8. Disconnect the electrical connector at the pressure transducer.
9. Remove the liquid condenser pipe connector block bolt at the receiver-dryer.
10. Remove the liquid condenser pipe from the vehicle.
11. Cap the opening at the receiver-dryer to prevent contamination.
Installation Procedure
1. Position the liquid condenser pipe section into the vehicle.
2. Install a new O-ring on the connector block at the receiver-dryer.
3. Install a new O-ring at the liquid condenser to evaporator plate pipe connector block.
4. Install the bolt securing the liquid condenser pipe connector block to the receiver-dryer.
Tighten
