Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
Center Mounted Brake Lamp: Service and Repair
Removal Procedure
1. Disconnect the negative battery cable.
2. Open the hatchback door.
3. Pry open the center high-mounted stoplamp (CHMSL) access cover with a screwdriver.
4. Disconnect the electrical connector.
5. Remove the screws and the CHMSL.
Installation Procedure
NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature corrosion.
1. Install the CHMSL with the screws.
Tighten
Tighten the CHMSL mounting screws to 3 Nm (27 lb.in).
2. Connect the electrical connector.
3. Close the CHMSL access cover.
4. Connect the negative battery cable.