Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
8. Bleed the hydraulic modulator:
8.1 Attach a clear plastic bleeder hose to the left side bleeder valve on the hydraulic modulator. Submerge the other end of the bleeder hose in a
clean container partially filled with brake fluid.
8.2 Slowly open the left-side bleeder valve 1/2 to 3/4 turn.
8.3 Have an assistant press the brake pedal and hold it down until the brake fluid begins to flow.
8.4 Close the bleeder valve and release the brake pedal. Repeat steps 5.2 and 5.3 until no air bubbles are present.
Tighten
Tighten the bleeder valve to 9 Nm (80 inch lbs.).
8.5. Repeat the procedure for the right-side bleeder valve.
IMPORTANT: Once fluid flows from both hydraulic modulator bleeder valves, the hydraulic modulator is sufficiently full of brake fluid.
However, it may not be completely purged of air. At this point, move to the wheel cylinders and the calipers and bleed them. This ensures
that the lowest points in the system are completely free of air. Then the hydraulic modulator can be purged of any remaining air.
9. Bleed the system according to one of the bleeding procedures below.
